Here's a step-by-step guide to installing the 23mm pipe camera skid, optimized for clarity and safety:
Installation Steps
1. Connect the Camera
1)Align the 23mm camera's connector with the skid's cable interface.
2)Rotate the camera clockwise to secure it firmly (ensure no cross-threading).
2. Prepare the Skid
1)Use a hex screwdriver to slightly loosen the side screws of the skid (do not remove them completely).
2)This allows flexibility for threading the cable connector.
3. Thread the Cable
1)Gently slide the front end of the skid through the cable connector's opening.
2)Ensure the cable is not twisted or pinched during this step.
4. Final Tightening
1)Once the skid is positioned correctly, re-tighten the side screws evenly on both sides.
2)Check stability by lightly tugging the camera-it should not wobble.
Contact Us
For technical support or bulk orders, email info@bestdertech.com or call +(86)-186-6531-5008, or Chat now.
Safety Reminder
Always de-energize the system before installation.

